The t D (calc-date) [date] command converts a
date form into a number, measured in days since Jan 1, 1 AD. The
result will be an integer if date is a pure date form, or a
fraction or float if date is a date/time form. Or, if its
argument is a number, it converts this number into a date form.
With a numeric prefix argument, t D takes that many objects (up to six) from the top of the stack and interprets them in one of the following ways:
The `date(year, month, day)' function builds a pure date form out of the specified year, month, and day, which must all be integers. Year is a year number, such as 1991 (not the same as 91!). Month must be an integer in the range 1 to 12; day must be in the range 1 to 31. If the specified month has fewer than 31 days and day is too large, the equivalent day in the following month will be used.
The `date(month, day)' function builds a pure date form using the current year, as determined by the real-time clock.
The `date(year, month, day, hms)' function builds a date/time form using an hms form.
The `date(year, month, day, hour, minute, second)' function builds a date/time form. hour should be an integer in the range 0 to 23; minute should be an integer in the range 0 to 59; second should be any real number in the range `[0 .. 60)'. The last two arguments default to zero if omitted.
The t J (calc-julian) [julian] command converts
a date form into a Julian day count, which is the number of days
since noon on Jan 1, 4713 BC. A pure date is converted to an integer
Julian count representing noon of that day. A date/time form is
converted to an exact floating-point Julian count, adjusted to
interpret the date form in the current time zone but the Julian
day count in Greenwich Mean Time. A numeric prefix argument allows
you to specify the time zone; Time Zones 参照 . Use a prefix of
zero to suppress the time zone adjustment. Note that pure date forms
are never time-zone adjusted.
This command can also do the opposite conversion, from a Julian day count (either an integer day, or a floating-point day and time in the GMT zone), into a pure date form or a date/time form in the current or specified time zone.
The t U (calc-unix-time) [unixtime] command
converts a date form into a Unix time value, which is the number of
seconds since midnight on Jan 1, 1970, or vice-versa. The numeric result
will be an integer if the current precision is 12 or less; for higher
precisions, the result may be a float with (precision-12)
digits after the decimal. Just as for t J, the numeric time
is interpreted in the GMT time zone and the date form is interpreted
in the current or specified zone. Some systems use Unix-like
numbering but with the local time zone; give a prefix of zero to
suppress the adjustment if so.
The t C (calc-convert-time-zones) [tzconv]
command converts a date form from one time zone to another. You
are prompted for each time zone name in turn; you can answer with
any suitable Calc time zone expression (Time Zones 参照 ).
If you answer either prompt with a blank line, the local time
zone is used for that prompt. You can also answer the first
prompt with $ to take the two time zone names from the
stack (and the date to be converted from the third stack level).
Go to the first, previous, next, last section, table of contents.
利用度数